Chevrolet Performance LS3 E-Rod 6.2L Long Block Crate Engine - 19421057

Replaces 19370414

E-ROD SYSTEMS HAVE IT ALL Each E-ROD crate engine system carries an official California Air Resources Board (CARB) E.O. number and includes complete emissions equipment, along with the engine controller and harness needed to get the engine running. The primary elements of each kit include:

• Chevrolet Performance crate engine
• Engine control module
• Exhaust manifolds
• Catalytic converters
• Mass airflow sensor and sensor boss
• Oxygen sensors and sensor bosses
• Air filter
• Accelerator pedal
• Evaporative emissions canister
• Instruction manual

E-ROD LS3 6.2L SYSTEM

• CARB EO#: D-126-32
• Horsepower: 430 @ 5,900 rpm
• Torque: 425 lb.-ft. @ 4,600 rpm

Rated at a strong 430 hp, the original E-ROD crate engine delivers big power with California emissions compliance for countless pre-1995 cars, trucks and SUVs. Along with great power, its aluminum block and heads, and composite intake manifold make it a lightweight performer, too, meaning your project vehicle will likely enjoy weight balance - with less weight over the front axle. We recommend the 4L65-E transmission to match with the E-ROD LS3, which Chevrolet Performance also offers as an inclusive Connect & Cruise E-ROD crate powertrain system. BUILDER'S NOTE To facilitate a complete E-ROD installation, the builder will need to source additional components to complete the assembly and get the vehicle running, including:

• Fuel tank
• Fuel lines (re-circulating or returnless)
• Fuel pump - 58 psi (400 kPa) for LC9 and LS3 or 65 psi (450 kPa) for LSA
• Fuel tank vent line from the tank to the evaporative emissions canister
• Purge line from the canister to the engine purge solenoid
• Air induction system that incorporates the mass airflow sensor
• Exhaust system behind the catalytic converters.

All E-ROD engines require a front-end accessory drive system suitable to the vehicle. The instruction manual included with each kit offers recommendations for the accessory drive kit, as well as the transmission, gear ratios and more. Chevrolet offers several configurations of accessory drive systems to suit different applications; and each allows the installer to easily delete air conditioning. Chevrolet Performance recommends the LS1 Engine Installation Guide P/N 88959384, which illustrates basic procedures and offers helpful tips on installing an LS engine into older vehicles. E-ROD systems do not come with a transmission. Chevrolet Performance recommends the SuperMatic(TM) 4L70-E - P/N 19244043 - four-speed automatic overdrive transmission, along with Chevrolet Performance's SuperMatic(TM) transmission controller P/N 19257634, for LC9 and LS3 systems. The LSA, with higher torque output, should use the SuperMatic(TM) 4L85-E, P/N 19300175, along with the SuperMatic(TM) transmission controller, P/N 19302410. *GM automatic transmissions are typically equipped with 40-tooth reluctor wheels for vehicle speed sensor output. GM late-model manual transmissions are typically equipped with a 17-tooth reluctor wheel. The Chevrolet Performance T56 Super Magnum six-speed manual (P/N 19329795) is equipped with a 40-tooth reluctor wheel.